Lines Matching refs:Enable

28 #Enable OBSS protection
57 # Enable DFS channel roam
73 # 1-Enable
89 #Enable/Disable Tx beamformee in SAP mode
92 # Enable Tx beamforming in VHT20MHz
100 #Enable Power Save offload
117 #Enable or Disable p2p device address administered
123 #Enable VHT on 2.4Ghz
140 # Disable/Enable GreenAP
144 #Enable/Disable LPASS support
151 # Enable or Disable Multi-user MIMO
152 # 1=Enable (default), 0=Disable
161 # Enable support for TDLS
166 # Enable support for Implicit Trigger of TDLS. That is, wlan driver shall
174 # Enable support for TDLS off-channel operation
205 #bit0 IPA Enable
215 # Enable Rx handling options
220 # Enable(Tx) fastpath for data traffic.
224 # Enable TCP Segmentation Offload
228 # Enable Generic Receive Offload
234 # Enable HT MPDU Density
238 # Enable flow steering to enable multiple CEs for Rx flows.
256 # Enable NAN discovery (NAN 1.0)
266 #Enable/Disable dual MAC feature
279 #Enable/Disable latency mode
284 # Enable/Disable NUD Tracking within driver
311 # Enable Target Wake Time support.
316 # Enable/Disable the Motion Aided Wireless Connectivity based NLO using this parameter
323 # Enable/disable oce feature for STA
327 # Enable/disable oce feature for SAP
331 #Enable/disable FILS discovery for SAP
338 #Enable/disable probe request deferral as per OCE spec
352 # Enable/disable esp feature
375 # Bit 0: Enable/Disable the BTM offload. Set this to 1 will enable and 0 will disable BTM offload.
404 # Enable NAN datapath
429 # Enable LFR3 subnet detection
432 #Enable APF in Active mode
438 # Enable or disable Probe Req Information Element whitelist. When enabled, IEs corresponding to bits
441 # 1=Enable, 0=Disable (default)
466 #Enable/Disable chain selection optimization for one chain dtim
471 # Enable/Disable rtt sta mac randomization
483 # Enable/Disable peer unmap confirmation support in Host
486 # Enable/Disable separate wifi aware interface
497 # Enable/Disable conversion from SARV1 to SARV2