Lines Matching refs:Enable

28 #Enable OBSS protection
56 # Enable DFS channel roam
72 # 1-Enable
85 #Enable/Disable Tx beamformee in SAP mode
88 # Enable Tx beamforming in VHT20MHz
96 #Enable Power Save offload
110 #Enable or Disable p2p device address administered
116 #Enable VHT on 2.4Ghz
133 # Disable/Enable GreenAP
137 #Enable/Disable LPASS support
144 # Enable or Disable Multi-user MIMO
145 # 1=Enable (default), 0=Disable
154 # Enable support for TDLS
159 # Enable support for Implicit Trigger of TDLS. That is, wlan driver shall
167 # Enable support for TDLS off-channel operation
198 #bit0 IPA Enable
208 # Enable Rx handling options
213 # Enable(Tx) fastpath for data traffic.
217 # Enable TCP Segmentation Offload
221 # Enable Generic Receive Offload
227 # Enable HT MPDU Density
231 # Enable flow steering to enable multiple CEs for Rx flows.
249 # Enable NAN discovery (NAN 1.0)
259 #Enable/Disable dual MAC feature
272 #Enable/Disable latency mode
277 # Enable/Disable NUD Tracking within driver
304 # Enable Target Wake Time support.
309 # Enable/Disable the Motion Aided Wireless Connectivity based NLO using this parameter
316 # Enable/disable oce feature for STA
320 # Enable/disable oce feature for SAP
339 # Enable/disable esp feature
362 # Bit 0: Enable/Disable the BTM offload. Set this to 1 will enable and 0 will disable BTM offload.
388 # Enable NAN datapath
413 # Enable LFR3 subnet detection
416 #Enable APF in Active mode
422 # Enable or disable Probe Req Information Element whitelist. When enabled, IEs corresponding to bits
425 # 1=Enable, 0=Disable (default)
450 #Enable/Disable chain selection optimization for one chain dtim
455 # Enable/Disable rtt sta mac randomization
467 # Enable/Disable peer unmap confirmation support in Host
473 #Enable/disable probe request deferral as per OCE spec