Searched refs:RSSI (Results 1 – 13 of 13) sorted by relevance
69 * (Re-)Association request on the basis of insufficient RSSI.74 * Delta RSSI - The difference in dB between the minimum RSSI at which76 * Retry Delay expires and the AP's measurement of the RSSI at which the84 * the received RSSI has improved by Delta RSSI.137 * OCE RSSI-based (Re-)Association rejection attribute.
53 * Called when the RSSI of the currently connected access point goes beyond the58 * @param currRssi RSSI of the currently connected access point.
48 * If set indicates that the RSSI monitor APIs are supported.332 * Start RSSI monitoring on the currently connected access point.335 * invoked to indicate if the RSSI goes above |maxRssi| or below |minRssi|.339 * @param maxRssi Maximum RSSI threshold.340 * @param minRssi Minimum RSSI threshold.354 * Stop RSSI monitoring.
124 * RSSI information.378 * is reached the highest RSSI results must be returned.429 * Access Point Beacon and Management frames RSSI (averaged).729 * RSSI values controlling clustering behavior per spec. RSSI values are specified without a sign,735 * RSSI value determining whether discovery is near (used if enabled in discovery by737 * RSSI values are specified without a sign, e.g. a value of -65dBm would be specified as 65.877 * Number of samples used to calculate RSSI.1432 * If RSSI filtering was enabled using |NanDiscoveryCommonConfig.useRssiThreshold| in discovery1433 * session setup then this field contains the received RSSI value. It will contain 0 if RSSI1435 * RSSI values are returned without sign, e.g. -70dBm will be returned as 70.
67 * -GERAN - RSSI68 * -CDMA2000 - RSSI
446 * UTRA carrier RSSI as defined in TS 25.225 5.1.4
29 signalThresholdInfo.signalMeasurement = SignalMeasurementType::RSSI; in TEST_P()54 signalThresholdInfo.signalMeasurement = SignalMeasurementType::RSSI; in TEST_P()78 signalThresholdInfo.signalMeasurement = SignalMeasurementType::RSSI; in TEST_P()199 signalThresholdInfo.signalMeasurement = SignalMeasurementType::RSSI; in TEST_P()
46 * -GERAN - RSSI47 * -CDMA2000 - RSSI
70 RSSI = 1,
1135 * If RSSI filtering was enabled using |NanDiscoveryCommonConfig.useRssiThreshold| in discovery1136 * session setup then this field contains the received RSSI value. It will contain 0 if RSSI1138 * RSSI values are returned without sign, e.g. -70dBm will be returned as 70.
788 int32_t rssi; // Received RSSI in GSM,1252 uint32_t dbm; // This value is the actual RSSI1254 // actual RSSI is -75, then this response value will1264 // RSSI value multiplied by -1.1265 // Example: If the actual RSSI is -75,
131 int16 RSSI; /* receive signal strength (in dBm) */ member164 int16 RSSI; /* receive signal strength (in dBm) */ member206 int16 RSSI; /* receive signal strength (in dBm) */ member3902 int16 RSSI; /* receive signal strength (in dBm) */ member
226 * Number of samples used to calculate RSSI.