page.title=Power consumption
@jd:body

<!--
    Copyright 2014 The Android Open Source Project

    Licensed under the Apache License, Version 2.0 (the "License");
    you may not use this file except in compliance with the License.
    You may obtain a copy of the License at

        http://www.apache.org/licenses/LICENSE-2.0

    Unless required by applicable law or agreed to in writing, software
    distributed under the License is distributed on an "AS IS" BASIS,
    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
    See the License for the specific language governing permissions and
    limitations under the License.
-->
<div id="qv-wrapper">
  <div id="qv">
    <h2>In this document</h2>
    <ol id="auto-toc">
    </ol>
  </div>
</div>

<h2 id="low_power_sensors">Low-power sensors</h2>
<p>Some sensor types are defined as being low power. Low-power sensors must
  function at low power, with their processing done in the hardware. This means
  they should not require the SoC to be running. Here are some low-power sensor
  types:</p>
<ul>
  <li> Geomagnetic rotation vector </li>
  <li> Significant motion </li>
  <li> Step counter </li>
  <li> Step detector </li>
  <li> Tilt detector </li>
</ul>
<p>They are accompanied by a low-power (<img src="images/battery_icon.png"
width="20" height="20" alt="Low power sensor" />) icon in the <a
href="sensor-types.html#composite_sensor_type_summary">Composite sensor type
summary</a> table.</p>
<p>These sensor types cannot be implemented at high power as their primary benefit
  is low battery use. These sensors are expected to be activated for very long
  periods, possibly 24/7. It is better to not implement a low-power sensor at all
  rather than implement it as high power, as it would cause dramatic battery
  drain.</p>
<p>Composite low-power sensor types, such as the step detector, must have their
  processing conducted in the hardware.</p>
<p>See the CDD for specific power requirements, and expect tests in CTS to
  verify those power requirements.</p>
<h2 id="power_measurement_process">Power measurement process</h2>
<p>The power is measured at the battery. For values in milliWatts, we use the
  nominal voltage of the battery, meaning a 1mA current at 4V must be counted as
  4mW.</p>
<p>The power is measured when the SoC is asleep, and averaged over a few seconds
  of the SoC being asleep, so that periodic spikes in power from the sensor chips
  are taken into account.</p>
<p>For one-shot wake-up sensors, the power is measured while the sensor doesn’t
  trigger (so it doesn’t wake the SoC up). Similarly, for other sensors, the
  power is measured while the sensor data is stored in the hardware FIFO, so the
  SoC is not woken up.</p>
<p>The power normally is measured as a delta with when no sensor is activated.
  When several sensors are activated, the delta in power must be no greater than
  the sum of the power of each activated sensor. If an accelerometer consumes
  0.5mA and a step detector consumes 0.5mA, then activating both at the same time
  must consume less than 0.5+0.5=1mA.</p>