Lines Matching refs:only

46 @code{L32R} instructions in the text section.  These options only affect
57 relocations.  Otherwise, only the PC-relative @code{L32R} relocations
85 @samp{--transform}; @samp{--no-transform} should only be used in the
155 specified opcodes, so the format name need only be specified in rare
164 If an opcode can only be encoded in a FLIX instruction but is not
194 Note that this special handling of underscore prefixes only applies to
202 The underscore prefix only applies to individual instructions, not to
352 (The @code{BNEZ.N} instruction would be used in this example only if the
375 @code{CALL12}) provide a PC-relative offset of only 512 Kbytes in either
418 (@code{J}) provide a PC-relative offset of only 128 Kbytes in either
424 areas unreachable by normal code execution flow, in that case they only
481 The Xtensa assempler uses trampolines with jump around only when it cannot
506 The @code{MOVI} machine instruction can only materialize values in the
531 The @code{L8UI} machine instruction can only be used with immediate
533 machine instructions can only be used with offsets from 0 to 510.  The
534 @code{L32I} machine instruction can only be used with offsets from 0 to
562 The Xtensa @code{ADDI} instruction only allows immediate operands in the
666 The @code{schedule} directive is recognized only for compatibility with
724 read-only 32-bit data accessed via @code{L32R} instructions.
823 directive is only needed to specify some other location for a literal
884 instructions.  These are relevant only for Xtensa configurations that
894 These directives do not change the @code{L32R} mode---they only cause