| /hardware/broadcom/wlan/bcmdhd/dhdutil/include/proto/ |
| D | wpa.h | 59 uint8 high;
71 uint8 high;
91 uint8 high;
100 uint8 high;
|
| /hardware/interfaces/audio/effect/2.0/ |
| D | IEnvironmentalReverbEffect.hal | 67 * Sets the room high frequencies level.
72 * Gets the room high frequencies level.
87 * Sets the ratio of high frequencies decay.
92 * Gets the ratio of high frequencies decay.
|
| /hardware/qcom/keymaster/ |
| D | QSEEComAPI.h | 282 int QSEECom_set_bandwidth(struct QSEECom_handle *handle, bool high);
|
| D | keymaster_qcom.cpp | 74 int (*QSEECom_set_bandwidth)(struct QSEECom_handle* handle, bool high);
|
| /hardware/libhardware_legacy/include/hardware_legacy/ |
| D | gscan.h | 232 wifi_rssi high; // high threshold member
260 wifi_rssi high; // high threshold member
|
| /hardware/interfaces/camera/device/3.2/ |
| D | types.hal | 100 * Special constrained high speed operation mode for devices that can not
101 * support high speed output in NORMAL mode. All streams in this
102 * configuration are operating at high speed mode and have different
103 * characteristics and limitations to achieve high speed output. The NORMAL
104 * mode can still be used for high speed output if the HAL can support high
106 * controls. It is recommended for the HAL to support high speed output in
107 * NORMAL mode (by advertising the high speed FPS ranges in
120 * 4. To achieve efficient high speed streaming, the HAL may have to
153 * high frame rate, within one batch, camera framework only propagates
160 * For more details about high speed stream requirements, see
[all …]
|
| /hardware/qcom/audio/post_proc/ |
| D | equalizer.c | 124 uint32_t *low, uint32_t *high) in equalizer_get_band_freq_range() argument
128 *high = equalizer_band_freq_range[band][1]; in equalizer_get_band_freq_range()
|
| /hardware/interfaces/light/2.0/ |
| D | types.hal | 117 * The high byte should be ignored. Callers will set it to 0xff (which
|
| /hardware/interfaces/camera/device/1.0/ |
| D | ICameraDeviceCallback.hal | 101 * reduce number of callbacks in performance intensive use cases, such as high speed video
|
| /hardware/qcom/wlan/qcwcn/wifi_hal/ |
| D | gscan.cpp | 642 apThreshold.high)) in wifi_set_bssid_hotlist()
651 apThreshold.low, apThreshold.high); in wifi_set_bssid_hotlist()
922 apThreshold.high)) in wifi_set_significant_change_handler()
932 i, apThreshold.low, i, apThreshold.high); in wifi_set_significant_change_handler()
|
| /hardware/interfaces/camera/common/1.0/ |
| D | types.hal | 355 * Based on the resourceCost fields, if a high-priority foreground
370 * due a shared physical sensor. Using the back and "high-power" front
|
| /hardware/interfaces/sensors/1.0/ |
| D | ISensors.hal | 85 * lost events, nor can transitioning from a high maximum report latency to
|
| D | types.hal | 536 * This sensor can be high power. It can use any and all of the following
1103 * more reources to improve throughput and latency in high performance mode.
1106 * int32_t: 1 or 0, denote if device is in/out of high performance mode,
|
| /hardware/broadcom/wlan/bcmdhd/wifi_hal/ |
| D | gscan.cpp | 1035 result = request.put_u8(GSCAN_ATTRIBUTE_RSSI_HIGH, mParams.ap[i].high); in createSetupRequest()
1458 result = request.put_u8(GSCAN_ATTRIBUTE_RSSI_HIGH, mParams.ap[i].high); in createSetupRequest()
|
| /hardware/interfaces/audio/common/2.0/ |
| D | types.hal | 665 // sample rate high enough to accommodate lower-range
|
| /hardware/interfaces/gnss/1.0/ |
| D | IGnssMeasurementCallback.hal | 257 * derived from a single, high quality clock (XO like, or better, that is
|
| /hardware/interfaces/graphics/common/1.0/ |
| D | types.hal | 1326 * the ITU-R Recommendation BT.709 / Rec. 709 for high-definition television.
|
| /hardware/interfaces/graphics/composer/2.1/ |
| D | IComposerClient.hal | 464 * Returns the high dynamic range (HDR) capabilities of the given display,
|
| /hardware/broadcom/wlan/bcmdhd/dhdutil/include/ |
| D | wlioctl.h | 3565 uint32 high; member
|
| /hardware/interfaces/wifi/1.0/ |
| D | types.hal | 1196 * Should the follow-up message be transmitted with a high priority.
|